Step 1
Begin by removing and separating the included hook-and-loop fasteners; these will later be used to secure the cord around the hose.
Next, connect it to a power bank to check that it is working. Press and hold the button to turn it on. Press and hold the button to turn it off.
Disconnect the power bank to install your Thermotip.
Step 2
Position the Thermotip under the nozzle, as close to the edge as possible. To prevent freezing, it is important that the heat reaches as far out as possible.
Approximately 1–1.5 cm from the edge is a good position, so you can continue drinking without any obstruction.
Thermotip is slightly flexible, allowing you to pull it a bit to create a snug fit.
Step 3
If you do not have an insulated cover, you can skip this step.
If you have an insulated hose, you can preferably attach the insulated cover on top of the Thermotip and thread the cord through the hook-and-loop fastener.
Step 4
Attach the cable to the outside of the hose using the provided hook-and-loop straps.
Secure the cable where you deem necessary, and then thread it through the hose holders on your belt.
Next, feed the USB connector through the hole in the belt and connect your power bank.
Step 5
Your Thermotip is now installed and ready for use.
Start it by holding down the button until the first light turns on.
Change modes by pressing the button.
To turn it off, hold down the button until the lights go out.